Specification of Wired Card Splitter
Feature :
Fast master <-->slave communication
restart automatically after power failure
Each slave to be independent on / off and will not affect the normal operation of other slave
Easily from the slave card to connect the host and the host each port can be an extension of a main line, the slave card only need to take a wire on the main line , not need every dragged a line from the card to the host
the distance between the host and the slave card can reach 150M
Support Eystem：Viaccess , Irdeto , Seca, Conax......
Suit for DVB-S, DVB-T, DVB-C conditional access system and all the products which needed
How to use wired card splitter
First : connect See detail icon
attention:connecting line is two core telephone cable,the joint must be cross wire.Between the host and client card not more than 100 meters distance
method of attachment one: series
This approach is suitable the family of the room small, a short distance
PIC ( 1 )
method of attachment two:Parallel
This approach applies to comparisons between the room and the rooms are more distant, and residential! As long as taking a theme, each room in the main line tie-line can be had! It is like pulling the wire!
PIC ( 2 )
Second:Connected to the power supply
Plug in the host the first charge card, draw a line on the power supply, the client card insert set-top box and opened the power of the box to get started.
attention :Some of the compatibility of set-top box may need to choose a different jumper (jumper by Vice card operation) mode to achieve, mainly in the following four kinds of situations jumper, set-top box can not be used when you were tested.you can test them each other
PIC ( 3 )
Support system Viaccess , Irdeto , Seca, Conax，......
|
|
|
|
| Select Image |
 |
|
|
|
|
