Splitter WTR-1

1.Install the antenna on the "ANTENNA" holder
2.Plug the "RS232" terminal into to the satellite receiver "RS232" socket
3.Connect the "DC 12V" cable to DC scoket.set the satellite receiver at "12V ON" state.
4.Set "CHANNEL" switch as same position as the master receiver.
5.Place the receiver in an open area.
Power on the master receiver and slaver receiver.
7.Master receiver set as "Server".
8.Slaver receiver set as "Client X" ("X" is number "1" to "8").each slaver receiver must be set to difference "Client number".
9.When completed above setting.then the receiver can be connected.

Notes:Above No.3,No.4,No.7,No.8 please refer to to satellite receiver user's manual.